TM 9-2320-289-20
Section Il. ILLUSTRATED MANUFACTURING INSTRUCTIONS -
1.
2.
3.
4.
1.
2.
3.
4.
1.
2.
3.
Continued
Fabricate from softwood plywood, ½ in. thick, NSN 5530-00-129-7777.
Using Figure FO-9, cut to dimensions shown and drill holes as indicated for Part
Number 14063347.
Remove all burrs.
Treat and seal wood per MIL-T-704J, paragraph 3.2.4. Prime with epoxy primer
coating (Item 39, Appendix C), per MlL-STD-193. Finish paint lusterless forest
green (Item 11, Appendix C) on both sides.
Figure D-48. Insulation.
Fabricate from softwood
Using Figure FO-10, cut
Part Number 14063348.
Remove all burrs.
plywood, ½ in. thick, NSN 5530-00-129-7777.
to dimensions shown and drill holes as indicated for
Treat and seal wood per MIL-T-704J, paragraph 3.2.4. Prime with epoxy primer
coating (Item 39, Appendix C), per MlL-STD-193. Finish paint lusterless forest
green (Item 11, Appendix C) on both sides.
Figure D-49. Insulation.
Fabricate from structural angle steel, 1 in. x 1 in., NSN 9520-00-855-7037.
Cut to 56.00 in. long for Part Number 14063350.
Remove all burrs.
Figure D-50. Molding.
D-23
