11-30. ROOF COVER AND ENDGATE CURTAIN REPLACEMENT (M1009)

11-30. ROOF COVER AND ENDGATE CURTAIN REPLACEMENT (M1009) (Cont) - TM-9-2320-289-20_737

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
715

TM 9-2320-289-20 11-30. ROOF COVER AND ENDGATE CURTAIN REPLACEMENT (M1009). This task covers: a. Removal b. Installation INITIAL SETUP: Materials/Parts Personnel Required • Sealing compound, corrosion-resistant • MOS 63B (2) (Item 42, Appendix C) a. REMOVAL NOTE • If removing roof cover (6), perform steps 1-8. • If removing endgate curtain (9), perform steps 2, 9, and 10. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Remove 4 screws (14) and radio antenna bracket (13) if present. Remove window flap (7) from 4 turnbuttons (8). Remove roof cover (6) from 4 turnbuttons (12). Remove 6 screws (15) and washers (16) on each side of truck. Pull roof cover (6) forward over cab of truck and place upside down. Remove 14 screws (2), washers (1), 2 side retainers (5), and 2 top retainers (3). Set screws aside for later use. Remove roof cover (6) from truck. Clean off corrosion-resistant sealing compound from cab roof. Remove endgate curtain (9) from 14 turnbuttons (10) and remove endgate curtain. Open endgate and inspect each side lip of endgate for tightness of 8 locknuts (11). b. INSTALLATION • If • If NOTE installing endgate curtain (9), perform steps 1 and 2. installing roof cover (6), perform steps 4-11. 1. Replace all broken turnbuttons (8 and 10) and tighten 8 locknuts (11). 2. Replace any loose or damaged expansion shields (4) by applying corrosion-resistant sealing compound to holes and installing new expansion shields. 3. Close endgate and install endgate curtain (9) to 14 turnbuttons (10). 11-108

Privacy Statement
Press Release
Contact