11-29. FRONT, SIDE, AND WHEEL HOUSE INSULATORS REPLACEMENT (M1008 AND M1008A1)

11-29. FRONT, SIDE, AND WHEEL HOUSE INSULATORS REPLACEMENT (M1008 AND M1008A1) (Cont) - TM-9-2320-289-20_733

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
711

TM 9-2320-289-20 11-29. FRONT, SIDE, AND WHEEL HOUSE INSULATORS REPLACEMENT (M1008 AND M1008A1). This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Condition Materials/Parts • Troop seat assembly removed. • One locknut (M1008) (See TM 9-2320-289-10) • Communications rack removed (M1008A1 only). (See paragraph 4-48) 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. • If • If • If • If Remove 4 Remove 4 Remove 8 removing removing removing removing NOTE wheel house insulator (21), perform steps 1-3. front side insulators (12), perform steps 1, 4, and 6. rear side insulators (13), perform steps 1, 2, 7, and 8. front insulator (23), perform steps 5, 9, and 10. screws (18) securing 2 brackets (10) to front side insulator (12). screws (18) securing 2 brackets (20) to rear side insulator (13). screws (18), 2 brackets (22), and wheel house insulator (21). Remove cable attached to dummy receptacle connector (11) at right sidewall if present. Remove 8 screws (18) securing 4 brackets (10) at front insulator (23). Remove 4 screws (18) at 2 brackets (10) and remove front side insulator (12). Remove 2 screws (14), bolts (16), bolts (17), and rear angle bracket (15). Remove 4 screws (18), bracket (19), and rear side insulator (13). Remove 2 bolts (7), washers (6), and wiring harness (5) from front insulator (23). Remove screw (8) and locknut (9) from ground wire (3) (M1008), or remove nut (2), ground strap (1), and ground wire (3) from stud (4) (M1008A1). Discard locknut. Remove front insulator (23) from truck. 11-104

Privacy Statement
Press Release
Contact