TM 9-2320-289-20
11-8.
CAB HEATER AND DIVERTER REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Equipment Condition
Materials/Parts
• Cab heater control cable disconnected from
• Two
Iockwashers
diverter assembly. (See paragraph 11-4,
• RTV sealant (Item 41, Appendix C)
REMOVAL, step 1)
• Rear battery box and supports removed.
(See paragraph 11-6)
Tools/Test Equipment
• Cab heater fuel lines disconnected.
• Torque
wrench
(See paragraph 11-7)
a.
REMOVAL
NOTE
• If removing diverter (8), perform steps 1-3.
• If removing cab heater (2), perform steps 1-4.
1.
Remove cab heater (2) cover and disconnect wiring harness assembly (1). Loosen clamp (5)
and disconnect blower inlet hose (4), Loosen clamp (7) and disconnect diverter hose (6).
Unscrew clamps (3) and completely open. Loosen clamp (9) and disconnect exhaust pipe
(10).
TA50058
11-28
