TM 9-2320-289-20
11-4.
HEATER CONTROL PANEL HOUSING REPLACEMENT (Con’t).
3.
Remove 3 nuts (11), Iockwashers
(10), and screws (7). Pull heater
control panel housing (9) until control
cable (2) and guide wire go through
grommet (4). Disconnect guide wire
and leave in place for installation.
Discard Iockwashers.
4.
Remove 4 bolts (14) and washers
(15). Remove mounting bracket (8)
from instrument panel (12). Remove
mounting nuts (13) as required.
b. INSTALLATION
NOTE
• Some
production
models
may
have
screw
(7)
installed
behind
mounting bracket (8).
• If installing heater control panel housing (9), perform steps 2-4.
1.
Install mounting nuts (13) if removed. Install mounting bracket (8) on instrument panel (12)
with 4 bolts (14) and washers (15). Tighten bolts to 50-65 lb.-in. (6–7 N•m).
2.
Connect guide wire to end of control cable (2). Pull control cable through grommet (4) with
guide wire, Install heater control panel housing (9) on mounting bracket (8) with 3 screws (7),
new Iockwashers (10), and nuts (11).
TA50040
11-10
