TM 9-2320-289-20
11-4.
HEATER CONTROL PANEL HOUSING REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Equipment Condition
Materials/Parts
• Heater control panel removed.
• Three Iockwashers
(See paragraph 11-3)
Tools/Test Equipment
• Torque
wrench
a. REMOVAL
NOTE
If removing heater control panel housing, perform steps 1-3.
1.
Loosen nut on clip (6). Remove push-on nut (5) and disconnect control cable (2) from diverter
assembly (1). Pull control cable through clip.
2.
Loosen retaining strap (3) and pull control cable (2) through retaining strap. Connect guide
wire to end of control cable to assist in installation.
TA50039
11-9
