TM 9-2320-289-20
10-33. AIR CONDITIONER COVER AND CONDENSER ASSEMBLY REPLACEMENT
(M1010) (Con’t).
3.
Remove bolt (15), washer (14), and ground wire (13) at clamp (2).
4.
Disconnect condenser motor connector (9) from capacitor connector (5).
5.
Remove screw (4), washer (6), and capacitor (7).
6.
Remove condenser motor (11) and fan (10) from clamp (2).
7.
Remove setscrew on fan (10) and remove fan from condenser motor (11).
8.
Remove insulator (12) from condenser motor (11).
b.
INSTALLATION
1.
2.
3.
4.
5.
6.
7.
8.
NOTE
If installing capacitor (7), perform steps 5-8.
Install insulator (12) on condenser motor (11).
Install fan (10) to condenser motor (11) with setscrew. Ensure that setscrew is indexed to flat
side of condenser motor shaft.
Position condenser motor (11) and fan (10) inside clamp (2).
Install ground wire and tighten condenser motor (11) and fan (10) with washer (14) and bolt
(15).
Install capacitor (7) with screw (4) and washer (6).
Connect condenser motor connector (9) to capacitor connector (5).
Position cover assembly (1) and connect 2 wires (8) at 2 condenser motors (11) and ground
wire at left condenser motor.
Install cover assembly (1) with 20 screws (3).
FOLLOW-ON TASKS:
• Connect both battery negative cables. (See paragraph 4-38)
• Check operation of condenser motor.
10-123
