10-21. ENDGATE MAINTENANCE (M1009)

Section IV. UTILITY TRUCK BODY MAINTENANCE

10-21. ENDGATE MAINTENANCE (M1009) (Cont) - TM-9-2320-289-20_566

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
544

TM 9-2320-289-20 10-21. ENDGATE MAINTENANCE (M1009). This task covers: a. Removal c. Assembly b. Disassembly d. Installation INITIAL SETUP: Equipment Condition Materials/Parts l Endgate window removed. l Three Iockwashers (See paragraph 10-22) Tools/Test Equipment Personnel Required l Torque wrench l MOS 63B (2) (if removing endgate) l Screwdriver bit set, J-29843 a. REMOVAL NOTE l If removing endgate (8), perform steps l Support endgate (8) on suitable maintenance. 1-3. support when performing l If removing run channel, latch rods, handle, or control assembly, perform DISASSEMBLY steps as required. 1. Remove nut (12), Iockwasher (11), and stud (9) from each frame extension (10). Discard Iockwashers. TA49985 10-70

Privacy Statement
Press Release
Contact