9-6. REAR BUMPER AND TIE-DOWN CLEVISES REPLACEMENT (ALL EXCEPT M1009)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
458

TM 9-2320-289-20 9-6. REAR BUMPER AND TIE-DOWN CLEVISES REPLACEMENT (ALL EXCEPT M1009). This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Condition Materials/Parts Trailer electrical receptacle disconnected. • Two cotter pins (See paragraph 4-41 ) • Six Iockwashers Pintle assembly and related brackets removed. • Ten locknuts (See paragraph 9-4) Blackout marker brackets removed from bumper, (See paragraph 4-27) Tools/Test Equipment Personnel Required • Torque wrench • MOS 63B (2) 1. Remove cotter pin (19). Support tie-down clevis clevis. Repeat step to remove other side tie-down Reinforcement (18) of nuts (17) and installation. NOTE is factory-installed with (21), and remove pin (20) and tie-down clevis. Discard cotter pins. locknuts and washers instead Iockwashers (16). Use nuts and Iockwashers for 2. Remove 2 nuts (17), Iockwashers (16), washers (15), bolts (14), and reinforcement (18), Discard Iockwashers. 3. Remove 8 locknuts (1), 4 bolts (10), and 4 bolts (11) on left or right side. Discard locknuts. 4. Remove 2 locknuts (3), bolts (5), and washers (4), and remove left and right tie-down extensions (2) through holes in bumper (12). Discard locknuts. 5. Remove clips securing wiring harness to bumper (12). Clear wiring harness from underneath bumper. NOTE • Bumper (12) is factory-installed with locknuts and washers instead of nuts (6) and Iockwashers (7), Use nuts and Iockwashers for installation. • Use an assistant to perform step 6. 6. Remove 4 nuts (6), Iockwashers (7), washers (8), and bolts (13) on left and right side. Remove bumper (12). Discard Iockwashers. 9-10

Privacy Statement
Press Release
Contact