TM 9-2320-289-20
9-2.
FRONT BUMPER, RADIATOR GRILLE GUARD, AND TIE-DOWN CLEVISES
REPLACEMENT.
This task covers:
a.
Removal
b. Installation
INITIAL SETUP:
Materials/Parts
Tools/Test Equipment
• Two
cotter
pins
• Torque
wrench
Personnel Required
General Safety Instructions
• MOS 63B (2)
• Use an assistant during removal and
installation of radiator grille guard.
a.
REMOVAL
WARNING
Radiator grille guard is heavy. Failure to use an assistant during removal
may cause serious injury to personnel.
NOTE
If removing radiator grille guard (10), perform step 1.
1.
Remove 6 nuts (4), washers (3), bolts (11), and radiator grille guard (10).
2.
Remove cotter pin (7) from pin (8) and remove tie-down clevis (9). Repeat step to remove
other tie-down clevis.
3.
Remove 2 blackout light brackets from bumper (1). (See paragraph 4-25)
4.
Remove 2 nuts (5), washers (3), bolts (1
5.
Remove weight classification marker (2).
b.
INSTALLATION
2), and bumper (1).
WARNING
Radiator grille guard is heavy, Failure to use an assistant during installation
may cause serious injury to personnel.
NOTE
If installing radiator grille guard (10), perform step 5.
1.
Install weight classification marker (2) to bumper (1).
9-2
