8-15. POWER STEERING PUMP, BELT, AND PULLEY REPLACEMENT

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
442

TM 9-2320-289-20 8-15. POWER STEERING PUMP, BELT, AND PULLEY REPLACEMENT. This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Condition • Alternator belts removed (if power steering pump belt). (See paragraph 4-2 or 4-3) Too/s/Test Equipment removing • Power steering pump pulley remover, J-25034-B • Steering pulley installer, J-25033-B • Air conditioner belt removed (M1010 only). • Open end wrench (See paragraph 3-35) (16 mm and 18 mm), J-33124 a. REMOVAL CAUTION DO NOT pry on power steering pump (5) reservoir or pull on filler neck when rotating power steering pump, Failure to follow this caution may result in damage to power steering pump. NOTE • If removing belt (1), perform step 1. • If removing power steering pump (5), perform steps 1-3. 1. Loosen adjusting nut (2) and adjusting bolts (7 and 12). Rotate power steering pump (5) to loosen belt (1). Remove belt from pulley (14), Discard belt if worn or damaged. NOTE On all except M1010, bolt (12) is removed from behind power steering pump (5). 2. Remove bolt (8), adjusting bolt (7), and bracket (9). Remove nut (10) and brace (11). Disconnect power steering lines at power steering pump (5). (See paragraph 8-14) 3. Remove adjusting nut (2), nut (3), and adjusting bolt (12). Remove power steering pump (5) and bracket (4) assembly. 4. Remove power steering pump pulley (14). 5. Remove 3 bolts (13) and bracket from power steering pump (5). 8-30 Change 2

Privacy Statement
Press Release
Contact