b. INSTALLATION - TM-9-2320-289-20

8-14. POWER STEERING LINES REPLACEMENT (Cont)

8-15. POWER STEERING PUMP, BELT, AND PULLEY REPLACEMENT

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
441

TM 9-2320-289-20 8-14. POWER STEERING LINES REPLACEMENT (Con’t). NOTE If disconnecting line (9) from rear of power steering pump (16), it may be necessary to remove power steering pump mounting hardware and pull out power steering pump. 4. Disconnect line (18) from power steering gear (13). Disconnect line (9) from power steering pump (16). Loosen clamp (17) and disconnect hose (10) from power steering pump. Remove hoses and lines as required. Loosen clamps (5 and 8), and disconnect hose (4) and pipe (6) as required. 5. Inspect all hoses (4, 10, and 15), pipes (6 and 11), lines (9 and 18), and fittings for damage. Replace as required. b. INSTALLATION CAUTION 1. 2. 3. 4. Remove all plugs before connection. NOTE Install clamps (3, 5, 8, 14, or 17) on disconnected hoses (4, 10, or 15) if removed. Connect hose (4) to pipe (6) and pipe to hose (10), Tighten clamps (5 and 8) if disconnected. Connect hose (10) to power steering pump (16) and tighten clamp (17). Connect line (9) to power steering pump. Connect line (18) to power steering gear (13), install power steering pump if removed. Connect hose (4) to power booster (2) and tighten clamp (3). Connect lines (9 and 18) to power booster. Install new seal (12) and outlet pipe (11) if removed. Connect hose (15) to power steering gear (13) and power steering pump (16), and tighten clamps (14). Install clip (7) on line (9), pipe (6), and line (18), and install with bolt (1), new Iockwasher (20), and nut (19). FOLLOW-ON TASKS: • Connect both battery negative cables. (See paragraph 4-38) • Bleed power steering system. (See paragraph 8-8) 8-29

Privacy Statement
Press Release
Contact