TM 9-2320-289-208-9.STEERING WHEEL AND DIRECTIONAL SIGNAL LEVER REPLACEMENT.This task covers:a. Removalb. InstallationINITIAL SETUP:Equipment ConditionTools/Test Equipment• Both battery negative cables disconnected,• Steering wheel puller(See paragraph 4-38)• Torque wrench1.2.3.NOTEIf removing directional signal lever (12), perform step 3.Remove horn button cover (5), Remove 3 screws inside cup (4) and remove cup, hornbushing (3), and horn contact spring (2) from steering(9), Remove insulator (8), eyelet (7), and spring (6).NOTEUsing alinement mark (11) onsteeringcolumnshaft,markposition of steering wheel forinstallation.wheel (1). Remove clip (10) and nutRemove steering wheel (1) usingsteering wheel puller.Push in directional signal lever (12)while rotating counterclockwise, thenrotate clockwise while pulling out toremove from steering column.b.INSTALLATIONNOTEIf installing directional signal lever (12), perform step 1.1.Aline pin on directional signal lever (12) with notch in steering column, and install directionalsignal lever while turning counterclockwise.NOTEEnsure that directional signal lever (12) is in “OFF” position whileinstalling steering wheel (1).2.Position steering wheel (1) using alinement mark (11).TA497298-18
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
