TM 9-2320-289-208-11.PITMAN ARM REPLACEMENT.This task covers:a. Removalb. InstallationINITIAL SETUP:Equipment ConditionMaterials/Parts• Truck raised and supported by frame on• One locknutjack stands.• Connecting rod socket disconnected frompitman arm. (See paragraph 8-10)Too/s/Test Equipment• Mechanical puller, J-6632-01• Torquewrencha.REMOVALNOTEMark position of pitman arm (3) onsteeringgearshaft (1) forinstallation.1.Remove locknut (5), washer (4), andbolt (2). Remove pitman arm (3)from steering gear shaft (1). Discardlocknut.b.INSTALLATIONCAUTIONIf a clamp-type pitman arm (3) is used, spread pitman arm with a wedgejust enough to slip pitman arm onto steering gear shaft (l). DO NOTspread pitman arm more than required to slip over steering gear shaft withhand pressure. DO NOT use a hammer to install pitman arm.NOTEBefore tightening locknut (5), ensure that position of pitman arm (3) isalined with marks made during removal.1.Position pitman arm (3) on steering gear shaft (1). Install bolt (2), washer (4), and new locknut(5). Tighten locknut to 95 Ib.-ft. (129 N•m).FOLLOW-ON TASKS:• Connect connecting rod socket to pitman arm. (See paragraph 8-10)• Remove jack stands and lower truck.TA497328-22
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
