6-7. FRONT AXLE SPINDLE AND WHEEL BEARINGS REPLACEMENT

Section II. FRONT AND REAR AXLES MAINTENANCE

6-8. REAR AXLE SHAFT REPLACEMENT (ALL EXCEPT M1009)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
358

TM 9-2320-289-20 6-7. FRONT AXLE SPINDLE AND WHEEL BEARINGS REPLACEMENT. This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Condition Materials/Parts • Rotor and caliper mounting bracket • Axle shaft seal removed. (See paragraph 8-4) • Spindle seal • Grease (Item 26, Appendix C) Tools/Test Equipment • Puller Kit NOTE 1985-87 M1009 trucks have a spindle (6) that is 0.25 in. (6.3 mm) longer than 1984 trucks. To remove spindle (6), it may be necessary to tap end with plastic or rubber mallet. 1. Grease wheel bearing assembly (5) and install in spindle (6). Install new spindle seal (4) into spindle with sealing lips facing outward, Install spacer (3) onto axle shaft (1 ) with chamfer toward axle housing. Install new axle shaft seal (2) with lip facing outward. 2. Install spindle (6). FOLLOW-ON TASKS: • lnstall caliper mounting bracket and rotor. (See paragraph 8-4) TA49649 6-14 Change 2

Privacy Statement
Press Release
Contact