TM 9-2320-289-20
5-2.
TRANSMISSION FILTER ASSEMBLY MAINTENANCE (Con’t).
1.
Clean
WARNING
Dry cleaning solvent P-D-680 is toxic
protective goggles and gloves and use
and flammable. Alwavs wear
only in a well-ventilated area.
Avoid contact with skin, eyes, and clothes and DO NOT breathe vapors.
DO NOT use near open flame or excessive heat. The solvent’s flash
point is 100°F-138°F (38°C-59°C). If you become dizzy while using
cleaning solvent, immediately get fresh air and medical help. If solvent
contacts eyes, immediately wash your eyes with water and get medical
aid.
Compressed air used for cleaning purposes will not exceed 30 psi
(207 kPa). Use only effective chip guarding and personnel protective
equipment (goggles/shield, gloves). Failure to follow this warning may
result in serious injury to personnel.
old
RTV
sealant
or
old
transmission oil pan gasket (11) from
lip of transmission oil pan (2) and
from transmission housing with dry
cleaning solvent. Thoroughly dry with
compressed air.
NOTE
When
cleaning
magnet (12),
ensure that all metal filings are
removed.
2.
Clean transmission oil pan (2) and
magnet (12) with dry cleaning
solvent.
Thoroughly
dry
with
compressed air.
1.
Install screen grommet (13) into neck
of transmission oil filter assembly (8).
NOTE
Note markings on intake pipe (14)
and ensure that it is installed
properly.
One end is marked
“FILTER” and other end is marked
“CASE.“
2.
Install new seal (7) and intake pipe
(14) into
transmission
oil filter
assembly (9).
5-4
