5-2. TRANSMISSION FILTER ASSEMBLY MAINTENANCE

C H A P T E R 5 T R A N S M I S S I O N A N D T R A N S F E R C A S E M A I N T E N A N CE

5-2. TRANSMISSION FILTER ASSEMBLY MAINTENANCE (Cont) - TM-9-2320-289-20_353

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
331

TM 9-2320-289-20 5-2. TRANSMISSION FILTER ASSEMBLY MAINTENANCE. This task covers: a. Removal c. Installation b. Cleaning INITIAL SETUP: Materials/Parts Tools/Test Equipment One seal Torque wrench One transmission filter assembly with screen grommet One transmission oil pan gasket Manual References Dry cleaning solvent (Item 15, Appendix C) LO 9-2320-289-12 Hydraulic fluid (Item 28, Appendix C) RTV sealant (Item 41, Appendix C) General Safety Instructions Always wear goggles when working on underside of truck. Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area. WARNING Always wear goggles when working on underside of truck. Hydraulic fluid spillage can occur when removing transmission oil pan. Failure to follow this warning may result in serious eye injury. 1. Place drain pan under transmission oil pan (2). NOTE Steps 2 and 3 only apply to trucks equipped with winterization kits. 2. Remove 2 bolts (1) and disconnect heat exchange pipe (6) from front of transmission oil pan (2). 3. Loosen clamp (3) and disconnect rear exhaust pipe (4) from transmission oil pan (2). 4. Remove 10 front and side transmission oil pan screws (5). Loosen 3 rear transmission oil pan screws (5) about 4 turns. TA49632 5-2

Privacy Statement
Press Release
Contact