4-45. RADIO FEED HARNESS REPLACEMENT (ALL EXCEPT M1010)

FOLLOW-ON TASKS - TM-9-2320-289-20_336

4-45. RADIO FEED HARNESS REPLACEMENT (ALL EXCEPT M1010) (Cont)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
316

TM 9-2320-289-20 4-45. RADIO FEED HARNESS REPLACEMENT (ALL EXCEPT M1010). This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Condition Materials/Parts Radio feed leads disconnected from accessory Two rivets wiring terminal board and radio terminal board Eleven straps (M1009). (See paragraph 4-46) (winterization kit heaters only) Cargo compartment floor panel insulators removed if equipped with winterization kits. (See paragraph 11-28 or 11-31) NOTE If removing radio feed harness (2) from all except M1009, perform steps 1-5 and steps 7-11. If removing radio feed harness (2) from M1009, perform 5 through 8, 10, and 11. Step 1 only applies to M1008A1 equipped with winterization compartment heater. Tag all leads and terminals for installation. steps 2, kit cargo 1. Remove 11 straps from radio feed harness (2) and winterization kit cargo compartment heater wiring harness. Discard straps. NOTE M1009 clip (7) is attached to stud with nut. 2. Remove screw (14) or nut and clip (7) from radio feed harness (2). 3. Remove screw (12) and clip (13) from wiring harness (2). 4. Remove nut (11), washer (10), screw (16), and clip (15). 5. Remove screws (6) and clips (8). 6. Pull floor mat and pad away from passenger compartment floor. 7. Remove screw (4) and clip (3). NOTE Only M1009 radio feed harness grommet (5) uses rivets (1). 8. Remove 2 rivets (1) from grommet (5). Discard rivets. 4-94

Privacy Statement
Press Release
Contact