TM 9-2320-289-204-44.RESISTOR AND BRACKET REPLACEMENT.This task covers:a. Removalb. InstallationINITIAL SETUP:Equipment ConditionMaterials/PartsBoth battery negative cables disconnected.Three Iockwashers(See paragraph 4-38)Air cleaner removed. (See paragraph 3-9)a.REMOVALNOTEIf removing resistors (7), perform steps 4-6.1.Loosen 2 nuts (16) and remove accessory wiring terminal board cover (1).NOTETag both ends of leads (5 and 9) and terminal for installation.2.Remove nut (2) and starwasher (3), and disconnect lead (5) from accessory wiring terminalboard (4).3.Remove nut and washer, and disconnect lead (9) from glow plug relay (13).4.Remove 3 bolts (15) and Iockwashers (14), and remove bracket and resistor assembly (6).5.Remove 4 nuts (10) and bolts (12), and separate resistor (7) assembly from bracket (6).6.Remove 2 nuts (8) and screws (11), and separate 2 resistors (7) from lead (5) and lead (9).b.INSTALLATION1.Assemble 2 resistors (7), lead (5), and lead (9) with 2 screws (11) and nuts (8).2.Attach resistor (7) assembly to bracket (6) with 4 bolts (12) and nuts (10).3.Install bracket and resistor assembly (6) with 3 new Iockwashers (14) and bolts (15).4.Connect lead (9) to glow plug relay (13) with nut and washer.5.Connect lead (5) to accessory wiring terminal board (4) with starwasher (3) and nut (2).6.Position accessory wiring terminal board cover (1) and tighten 2 nuts (16).4-92
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
