TM 9-2320-289-20
4-27.
MARKER LIGHT AND LAMP REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Equipment Condition
Tools/Test Equipment
Both battery negative cables disconnected.
Screwdriver bit set, J-29843
(See paragraph 4-38)
NOTE
1.
2.
3.
If removing side marker light and
If removing blackout marker light
If removing blackout marker light
Remove 2 screws (5), side marker
light housing (4), and 2 retaining nuts
(1). Remove lamp (3) from wiring
harness connector (6).
Remove nut (11) and wiring harness
(10) ground. Remove two nuts (13).
Disconnect blackout marker light (8)
from wiring harness connector.
Remove bolt (7), nut (12), and
mounting bracket (9) from bumper
(14).
lamp (3), perform step 1.
(8), perform step 2.
bracket (9), perform steps 2 and 3.
TA49889
4-53
