FOLLOW-ON TASKS - TM-9-2320-289-20

4-5. STARTER AND STARTER RELAY REPLACEMENT (Cont)

S e c t i o n I l l . I N S T R U M E N T S , S E N D I N G U N I T S , S W I T C H E S, A N D H O R N M A I N T E N A N C E

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
235

TM 9-2320-289-20 4-5. STARTER AND STARTER RELAY REPLACEMENT (Con’t). NOTE Starter pinion tooth-to-flywheel clearance may be measured using a wire gage. 4. Remove 6 bolts (25) and access cover (27) from transmission housing (26) . Measure clearance between starter pinion (24) tooth and flywheel (23). Clearance should be 0.02 in. to 0.06 in. (0.50 mm to 1.50 mm). Add shims (10) as required. Install access cover (27) with 6 bolts. 5. Install bracket (4) on starter (7) and starter shield (2) with bolt (3), washer (6), and new locknut (5). Tighten bolt to 33 Ib.-ft. (45 N•m). FOLLOW-ON TASKS: Connect both battery negative cables. (See paragraph 4-38) TA49856 4-14

Privacy Statement
Press Release
Contact