b. INSTALLATION - TM-9-2320-289-20

4-5. STARTER AND STARTER RELAY REPLACEMENT

4-5. STARTER AND STARTER RELAY REPLACEMENT (Cont)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
233

TM 9-2320-289-20 4-5. STARTER AND STARTER RELAY REPLACEMENT (Con’t). NOTE Note position of battery terminal and solenoid terminal leads (12 and 14) before removing from solenoid (11). 2. Remove 2 nuts (15), battery terminal lead (12), solenoid terminal lead (14), and Iockwasher (13) from solenoid (11). Discard Iockwasher. WARNING Support starter (7) during removal. Failure to support starter may cause it to fall, resulting in injury to personnel. NOTE 1985-87 model starters (7) may not have shims (10). 3. Remove 2 screws (9) and washers (8), and carefully lower starter (7). Remove starter and shims (10). Remove screw (1) and starter shield (2) as required. 4. Remove 2 screws (18) from diagnostic connector bracket (19), dash panel (17), and wiring harness accessory bracket screw (20). Unplug remove starter relay b. INSTALLATION NOTE If installing starter perform step 1. (16). Remove lead (22) and (21). relay (21), If installing starter (7), perform steps 2-5. 1. Plug lead (22) into starter relay (21). Install starter relay on wiring harness accessory bracket (16) with screw (20). Install diagnostic connector bracket (19) and wiring harness accessory bracket on dash panel (17) with 2 screws (18). TA49854 4-12

Privacy Statement
Press Release
Contact