TM 9-2320-289-20
4-4.
ALTERNATOR REGULATOR REPLACEMENT AND ADJUSTMENT (M1010).
This task covers:
a.
Removal
b. Installation
INITIAL SETUP:
Equipment Condition
MaterialslParts
Both battery negative cables disconnected.
Five Iockwashers
(See paragraph 4-38)
a.
REMOVAL
1.
Remove nut (1) and Iockwasher (2),
and
disconnect
lead
(3)
from
regulator (6). Discard Iockwasher.
CAUTION
DO NOT pry on regulator (6) to
remove.
Failure to follow this
caution may result in damage to
regulator.
2.
R e m o v e 4
screws
(4)
and
Iockwashers
(5) ,
and
remove
regulator (6). Discard Iockwashers.
b.
INSTALLATION
1.
Ensure that adjustment screw (7) is in
“HI” position.
2.
Install regulator (6) on alternator (8)
with 4 new Iockwashers (5) and
screws (4).
3.
Connect lead (3) to regulator (6) and
install new Iockwasher (2) and nut
(1).
FOLLOW-ON TASKS:
Connect both battery negative cables. (See paragraph 4-38)
TA49852
4-10
