TM 9-2320-289-20
3-27.
EXHAUST PIPE, MUFFLER, AND TAILPIPE REPLACEMENT (Con’t).
NOTE
M1009 exhaust system has a support assembly in frame at rear of both
mufflers and a hanger assembly in frame at rear of exhaust pipe on
right side only.
Factory-installed support or hanger assemblies are riveted to frame.
Replacement support or hanger assemblies are installed with bolts,
Iockwashers, and nuts.
Perform step 10 only if working on M1009.
10.
Remove and discard hanger or support assemblies only if damaged.
b.
INSTALLATION
Installation
NOTE
of left side exhaust systems
described in this paragraph.
Right side exhaust systems for all except
for all except M1009 is
M1009 and both sides of
M1009 exhaust system are installed the same way except for minor
differences which will be described as they occur.
M1009 exhaust system has a support assembly in frame at rear of both
mufflers and a hanger assembly in frame at rear of exhaust pipe on
right side only.
Perform step 1 only if working on M1009.
1.
Install new hanger or support assemblies if required.
2.
Install new seal (25) at exhaust manifold. Install exhaust pipe (17) with 3 springs (26), washers
(27), and nuts (28). Tighten nuts to 180 lb.-in. (20 N•m).
Perform
3.
Install rear portion
Iockwashers.
NOTE
step 3 for all except M1009 left side exhaust systems.
of exhaust pipe (17) to front portion with clamp kit (29) using 2 new
3-78
