TM 9-2320-280-34
22-9.5. RIGHT REAR FLOOR PANEL REPAIR (Cont'd )
b. Reinforcement Strips Fabrication
1.
Cut reinforcement strip (1) from sheet metal, and mark four reference lines (2), centerline (3), and
identify as A on reinforcement strip (1).
2.
Locate, mark, and drill twenty-one 0.187-in. diameter holes and a 0.750-in. diameter hole through
reinforcement strip A (1).
3.
Remove all burrs and round sharp edges of reinforcement strip A (1).
4.
Cut reinforcement strip (4) from sheet metal, and mark four reference lines (5) and centerline (6).
Identify reinforcement strip (1) as B.
5.
Locate, mark, and drill eighteen 0.187-in. diameter holes and a 0.500-in. diameter hole through
reinforcement strip B (4).
6.
Remove all burrs and round sharp edges of reinforcement strip B (4).
22-16.74
Change 1
