TM 9-2320-280-34
This task covers:
a. Right Rear Insert Panel Fabrication
g.
Metal Strip C and Insert Panel Assembly
b. Reinforcement Strips Fabrication
h.
Metal Strip E and Insert Panel Assembly
c. Metal Strips Fabrication
i.
Metal Strip D and Insert Panel Assembly
d. Right Rear Floor Panel Removal
j.
Right Rear Floor Panel and Insert Panel Drilling
e. Reinforcement Strip A and Insert Panel Assembly
k.
Insert Panel and Right Rear Floor Panel Installation
f. Reinforcement Strip B and Insert Panel Assembly
INITIAL SETUP:
Tools
Equipment Condition
General mechanic's tool set
Right seat back removed
automotive (Appendix G, Item 1)
(TM 9-2320-280-20).
Right rear seat bottom removed
Manual References
(TM 9-2320-280-20).
TM 9-2320-280-20
Right rear floor insulation removed
TM 9-2320-280-24P
(TM 9-2320-280-20).
TM 43-0139
Maintenance Level
Materials/Parts
General Support
Eighty-five blind rivets (Appendix E, Item 194)
Sixty blind rivets (Appendix E, Item 195)
Adhesive (Appendix B, Item 1.1)
Adhesive sealant (Appendix B, Item 4.1)
Sheet metal (Appendix E, Item 245)
NOTE
All dimensions in this procedure are in inches.
a. Right Rear Insert Panel Fabrication
1.
Cut insert panel (1) from sheet metal, and mark four reference lines (3) and directional arrow (2) on
insert panel (1).
2.
Locate, mark, and drill six 0.312-in. diameter holes and one 1.00-in. diameter hole through
insert panel (1).
3.
Fabricate two drain holes (4) in insert panel (1).
4.
Bend insert panel (1) 1.50 in.
5.
Remove all burrs and round all sharp edges of insert panel (1).
Change 2
