TM 9-2320-280-34
19-3. DIFFERENTIAL REPAIR (Cont'd)
3.
Inspect splines and sealing surfaces on output flanges (1), pinion yoke (2), dirt deflector (2.1), and
output shafts (3) for damage. Replace if damaged.
NOTE
If rear pinion yoke is being replaced, a new slinger must be
installed on new pinion yoke.
Push rear pinion yoke into slinger until slinger is seated
against rear shoulder of yoke.
4.
Inspect all bearings (4) and bearing cups (5) for damage. Replace bearings (4) and bearing cups (5)
in matched sets if either are damaged.
5.
Inspect differential case (6) for damage. Replace if damaged.
2
2.1
Change 2
