TM 9-2320-280-34
18-3. TRANSFER CASE REPAIR (Model 218) (Cont'd)
52.
Remove two nuts (5), lockwashers (4) and output yokes (7) and (3) from transfer case (1).
53.
Remove two capscrews (2) and rear retainer (6) from transfer case (1).
NOTE
Ensure that the word "outside," molded on the seal, is facing the
yoke seal installer.
54.
Using yoke seal installer, install seal (8) in rear retainer (6).
55.
Apply sealing compound to threads of elbow (9).
56.
Install elbow (9) into rear retainer (6).
57.
Apply silicone sealant to rear retainer (6) mating surface. Align and install rear retainer (6) on
transfer case (1) with six capscrews (2). Tighten capscrews (2) to 22 lb-ft (30 N.m).
58.
Install front output yoke (7) and rear output yoke (3) on transfer case (1) with two lockwashers (4)
and nuts (5). Tighten nuts (5) to 110 lb-ft (149 N.m).
18-24
Change 2
