TM 9-2320-280-34
18-4. TRANSFER CASE REPAIR (MODEL 242) (Cont' )
d
8.
Remove snapring (1) from mainshaft assembly (2).
9.
Remove four capscrews (3) from rear retainer (4) and rear half-case (5).
10.
Prying on tabs of rear retainer (4), remove rear retainer (4) from rear half-case (5) and mainshaft (2).
11.
Remove two snaprings (6) and speedometer drive gear (7) from mainshaft assembly (2).
12.
Remove two capscrews (10) and washers (11) from rear half-case (5).
NOTE
Mark positions of long screws for installation.
13.
Remove two long screws (9) from front output end of rear half-case (5).
14.
Remove seven screws (8) from rear half-case (5).
NOTE
Use slots in half-cases when separating half-cases.
15.
Pry and remove rear half-case (5) from front half-case (17). Lay rear half-case (5) on bench with oil
pump (15) up.
CAUTION
Mark position of oil pump to rear half-case before removal. Failure to do so will
cause damage to equipment.
16.
Rotate oil pickup tube (13) and oil screen (14) out of rear half-case (5) and pull pickup tube (13) out
of oil pump inlet port (12).
17.
Remove oil pump (15) from rear half-case (5).
18-28
