TM 9-2320-280-34
18 - 3. TRANSFER CASE REPAIR (Model 218) (Cont' )
d
47.
Align and install rear retainer (16) to rear case (9) with two capscrews (20) opposite each other.
Tighten capscrews (20) to 22 l-ft (30 N.m).
48.
Install front output yoke (18) and seal washer and nut (19) on front output shaft (17). Install rear
output yoke (15) and seal washer and nut (14) on rear output shaft (4). Finger tighten only.
49.
Mount dial indicator on rear retainer (16), index dial indicator so it contacts top of yoke nut (14).
50.
Rotate front output yoke (18) ten complete revolutions and zero dial indicator at the highest point.
51.
Lift up on rear output yoke (15) and note end play reading on dial indicator. End play should be
0.008-0.020 in. (0.20-0.51 mm). If end play is corr ct, go to next step. If end play must be adjusted,
e
remove rear retainer and add or subtract shims as necessary and recheck end play.
18-23
