TM 9-2320-280-34
This task covers:
a.
Rear Band
k.
Detent Solenoid
b.
Gear Unit and Center Support
l.
Front Servo
c.
Establish Rear End Play
m.
Rear Servo
d.
Intermediate Clutch
n.
Control Valve
e.
Front Band
o.
Governor
f.
Manual Linkage
p.
Oil Filter
g.
Direct Clutch
q.
Oil Pan
h.
Forward Clutch and Turbine Shaft
r.
Holding Fixture
i.
Oil Pump
s.
Torque Converter
j.
Establish Front End Play
INITIAL SETUP:
Applicable Models
Materials/Parts
All vehicles except: M997A2, M1025A2,
Gasket (Appendix E, Item 28)
M1035A2, M1043A2, M1045A2, M1097A2,
Gasket (Appendix E, Item 38)
M1123
Gasket (Appendix E, Item 24)
Gasket (Appendix E, Item 25)
Tools
Fluid parts kit (Appendix E, Item 158)
General mechanic's tool kit:
Nonmetallic seal (Appendix E, Item 214)
automotive (Appendix G, Item 1)
Gasket (Appendix E, Item 22)
Dial indicator (Appendix G, Item 95)
Packing retainer (Appendix E, Item 187)
Gasket (Appendix E, Item 34)
Special Tools
Three clutch disks (Appendix E, Item 8)
Band apply pin selector gauge
Transmission fluid (Appendix B, Item 23)
(Appendix G, Item 37)
Petrolatum (Appendix B, Item 38)
Slide hammer adapter (Appendix G, Item 32)
Two guide pins (Appendix C, Fig. 2)
Gear unit holding tool (Appendix G, Item 31)
Intermediate clutch alignment tool
Personnel Required
(Appendix G, Item 38)
One mechanic
Torque adapter, 9/16 in.
One assistant
(Appendix G, Item 109)
Manual References
TM 9-2320-280-24P
Maintenance Level
General support
CAUTION
All transmission parts must be lubricated with clean transmission
fluid before assembly. Foreign material will cause transmission
damage.
NOTE
During assembly operations, it is important to closely inspect
each unit to make sure nothing has been overlooked during
inspection and repair. Plugs should be checked for tightness,
parts kept clean, openings covered, and machined surfaces
protected. Application of lubricant should be performed from
covered containers.
For general assembly instructions, refer to para. 2-16.
Install transmission holding fixture (para. 17-3.b.).
If using new transmission case, discard blue plug and copper
plug that are packaged with transmission case. These plugs are
not required on M998 and M998A1 vehicles.
The speedometer drive opening must be plugged with seal plug
P/N 8623463 on new transmission case.
Change 2
