TM 9-2320-280-34
This task covers:
a.
Torque Converter
j.
Oil Pump
b.
Holding Fixture
k.
Forward Clutch and Turbine Shaft
c.
Oil Pan
l.
Direct Clutch
d.
Oil Filter
m.
Manual Linkage
e.
Governor
n.
Front Band
f.
Control Valve
o.
Intermediate Clutch
g.
Detent Solenoid
p.
Gear Unit
h.
Front Servo
q.
Center Support
i.
Rear Servo
r.
Rear Band
INITIAL SETUP:
Applicable Models
Personnel Required
All vehicles except: M997A2, M1025A2,
One mechanic
M1035A2, M1043A2, M1045A2, M1097A2,
One assistant
M1123
Equipment Condition
Tools
Transmission prepared for disassembly (para. 7-
General mechanic's tool kit: automotive
(Appendix G, Item 1)
General Safety Instructions
Special Tools
Torque converter must be supported during
Transmission holding fixture
removal.
(Appendix G, Item 29)
Maintenance Level
Transmission holding fixture base
(Appendix G, Item 30)
General support
Two slide hammer adapters
(Appendix G, Item 32)
Gear unit holding tool
(Appendix G, Item 31)
a. Torque Converter
WARNING
Torque converter must be supported during removal and
installation. Failure to do this may cause injury to personnel or
damage to equipment.
NOTE
Ensure torque converter turns freely. Record any abnormal
looseness or noises.
Remove torque converter (2) from transmission (1).
b. Holding Fixture
CAUTION
Do not overtighten screws. This will bind center support.
1.
Install transmission holding fixture into locating holes on side of transmission (1).
2.
Install transmission holding fixture and transmission (1) into transmission holding fixture base.
3.
Position front of transmission (1) up and allow to drain.
Change 2
