TM 9-2320-280-34
This task covers:
a. Disassembly
c. Inspection
b. Cleaning
d. Assembly
INITIAL SETUP:
Tools
Manual References
General mechanics tool kit: automotive
TM 9-2320-280-20
(Appendix G, Item 1)
TM 9-2320-280-24P
Maintenance and repair shop equipment:
Equipment Condition
automotive (Appendix G, Item 2)
Winch removed (TM 9-2320-280-20)
Materials/Parts
Maintenance Level
Four copper washers (Appendix E, Item 259)
Direct Support
Two square cut O-rings
(Appendix E, Item 153)
O-ring (Appendix E, Item 139)
Two drum end O-rings
(Appendix E, Item 152)
O-ring (Appendix E, Item 140)
Two O-rings (Appendix E, Item 141)
Grease (Appendix B, Item 20)
Sealing compound (Appendix B, Item 51)
Hydraulic fluid (Appendix B, Item 24)
a. Disassembly
NOTE
Tag hydraulic lines for assembly
1.
Remove banjo screw (8), two copper washers (9), and inlet banjo tube (10) from valve and solenoid
assembly (3). Discard copper washers (9).
2.
Remove banjo screw (6), two copper washers (5), and outlet banjo tube (7) from valve and solenoid
assembly (3). Discard copper washers (5).
NOTE
Restrictor, restrictor washer, and O-ring may come out of valve
and solenoid assembly during removal. Be careful to catch parts
during disassembly.
3.
Remove four socket-head screws (4) and valve and solenoid assembly (3) from motor (1).
4.
Remove two O-rings (2) from motor (1). Discard O-rings (2).
5.
Remove restrictor (11), restrictor washer (13), and O-ring (12) from valve and solenoid
assembly (3).
Change 2
