TM 9-2320-280-34
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Equipment Condition
All except M996, M996A1, M997, M997A1,
Cargo shell door removed (TM 9-2320-280-20).
M997A2, M998, M998A1, M1035, M1035A1,
Front and rear strikers removed
M1035A2, M1037, M1038, M1038A1,
(TM 9-2320-280-20).
M1042, M1097, M1097A1, M1097A2
Antenna removed (TM 9-2320-280-20),
if present.
Tools
Dovetail spring removed (TM 9-2320-280-20).
General mechanic's tool kit:
M966, M966A1, M1036, M1045, M1045A1,
automotive (Appendix G, Item 1)
M1045A2, M1046, and M1046A1 only:
Materials/Parts
M16 ammo rack removed, left cargo shell
Eight locknuts (Appendix E, Item 63)
only (TM 9-2320-280-20).
Nine locknuts (Appendix E, Item 55)
M1043, M1043A1, M1043A2, M1044,
Four locknuts (Appendix E, Item 57)
and M1044A1 only:
Seven blind rivets (Appendix E, Item 191)
Assembled locknut (Appendix E, Item 85)
Ammo box tray removed (TM 9-2320-280-20).
Grease (Appendix B, Item 21)
Maintenance Level
Adhesive tape (Appendix B, Item 58)
Direct support
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-280-20
TM 9-2320-280-24P
NOTE
The procedures for removing and installing the right cargo shell
and left cargo shell are basically the same. This procedure covers
the right cargo shell.
For instructions on replacement of rivets, refer to para. 22-7.
a. Removal
1.
Remove seven rivets (19) and panel (18) from cargo shell (8) and wheelhouse (11).
2.
Remove two locknuts (9), washers (10), and screws (13) from cargo shell (8) and striker mounting
plate (12). Discard locknuts (9).
3.
Remove nine locknuts (14), washers (7), capscrews (6), washers (7), and spacers (17) from cargo
shell (8) and wheelhouse (11). Discard locknuts (14).
4.
Remove two locknuts (15), washers (16), capscrews (20), and washers (16) from cargo shell support
tube (2) and wheelhouse (11). Discard locknuts (15).
5.
Remove two locknuts (5), washers (4), capscrews (3), and washers (4) from cargo shell support
tube (2) and "C" pillar (1). Discard locknuts (5).
6.
Remove capscrew (28), washer (27), snubber (26), mount (25), bushing (24), and plate (22) from rear
ring support (23) and "C" pillar support bracket (21).
Change 2
