TM 9-2320-280-34
14-6. CARGO SHELL REPLACEMENT (Cont'd)
13.
Remove mount (4), snubber (3), and shim(s) (2) if present, from between rear ring support (1) and
"C" pillar support bracket (5).
14.
Remove two mounts (11) and snubbers (10) from between right and left rear roof mounts (7) and
cargo shell support tubes (12).
CAUTION
Do not lift cargo shell further than limits specified in step 16.
Raising cargo shell too far may cause damage to "C"pillar.
15.
Lift roof (8) far enough to allow cargo shell (13) to clear lip (9).
16.
Raise cargo shell (13) approximately 1 in. (2.5 cm) and rap cargo shell support tube (12) at point "A"
with a mallet to loosen cargo shell (13), taking care not to bend "C" pillar (6). Remove cargo
shell (13).
17.
Remove cargo shell seal (14) and inspect for damage. Replace if damaged.
18.
Remove adhesive tape from cargo shell (13). Discard tape.
b. Installation
1.
Apply adhesive tape to cargo shell (13) and wheelhouse (15) mounting surface.
2.
Coat inside surface of support tube (12) that makes contact with outside surface of "C" pillar (6)
with grease.
3.
Raise and support roof (8).
4.
Lift rear of cargo shell (13) slightly while installing cargo shell support tube (12) over "C" pillar (6).
5.
Align cargo shell seal (14) between cargo shell (13) and wheelhouse (15).
6.
When cargo shell support tube (12) is installed over "C" pillar (6) and cargo shell (13) is aligned
with wheelhouse (15) lower cargo shell (13) ensuring cargo shell (13) is inside of lip (9) at roof (8).
7.
Install snubber (3), mount (4), and shim(s) (2) if removed, between rear ring support (1) and
"C" pillar support bracket (5).
8.
Install two snubbers (10) and mounts (11) between right and left rear roof mounts (7) and cargo
shell support tube (12).
9.
Install footman loop (18) to wheelhouse (15) with two screws (19), washers (17), and nuts (16).
1
2
3
4
5
14-26
Change 2
