TM 9-2320-280-34
14-5. WINDSHIELD MAINTENANCE (Cont'd)
7.
Install three hinge pins (2) in lower hinges (3) with three hitch pins (1).
8.
Install two "B" pillar covers (7) on roof (4) with four washers (6) and screws (5). Tighten screws (5)
to 15 lb-ft (20 Nm).
NOTE
Perform step 9 for M966, M966A1, M1036, M1045, M1045A1,
M1045A2, M1046,and M1046A1 TOW vehicles.
9.
Install TOW wiring harness clamp (10) on right side front "B" pillar cover screw (8) with assembled
locknut (9).
10.
Install two bushings (22) four mounts (21) and snubber plates (12) on windshield support
mounts (23) and roof mounting plates (11) with two washers (15), studs (16), and locknuts (17).
Tighten locknuts (17) to 37 lb-ft (50 Nm).
11.
Tighten two locknuts (13) to 26 lb-ft (35 Nm).
12.
Place shims (20) between rear windshield mounting brackets (18) and windshield (14) as required
to fill gap.
13.
Install two rear windshield mounting brackets (18) on windshield (14) with six capscrws (19).
Tighten capscrews (19) to 15 lb-ft (20 Nm).
4
1
5
6
2
7
3
14-20
Change 2
