TM 9-2320-280-34
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
INITIAL SETUP:
Applicable Models
Personnel Required
All except M996, M996A1, M997, M997A1,
One mechanic
M997A2, M998, M998A1, M1035, M1035A1,
One assistant
M1035A2, M1037, M1038, M1038A1, M1042,
Manual References
M1097, M1097A1, M1097A2
TM 9-2320-280-20
Tools
TM 9-2320-280-24P
General mechanic's tool kit:
Equipment Condition
automotive (Appendix G, Item 1)
Turret bearing removed
Materials/Parts
(TM 9-2320-280-20).
Six spring pins (Appendix E, Item 172)
Roof removed (para. 14-3).
Eight locknuts (Appendix E, Items 63)
Maintenance Level
Eight locknuts (Appendix E, Item 57)
Direct support
Assembled locknut (Appendix E, Item 85)
a. Removal
NOTE
Note location of attaching hardware for installation.
1.
Remove two locknuts (6), washers (3), capscrews (4), washers (3), and front supports (2) from front
mounting clevises (5). Discard locknuts (6).
2.
Remove four locknuts (14), capscrews (9), two striker plates (8), and strap brackets (15) from "B"
pillars (12). Discard locknuts (14).
3.
Remove four locknuts (13), washers (11), capscrews (10), washers (11), and support ring (1) from
two "B" pillars (12). Discard locknuts (13).
4.
Remove four edge trim strips (7) from "B" pillar covers (16).
NOTE
Perform steps 5 and 6 for M966, M966A1, M1045, M1045A1,
M1045A2, M1046, M1046A1, and M1036 TOW vehicles only.
5.
Remove assembled locknut (28) and screw (30) from right "B" pillar cover (16) to free TOW wiring
harness clamp (27) from right "B" pillar cover (16). Discard assembled locknut (28).
6.
Remove two capscrews (25), washers (26), and cable stowage cleat (29) from support ring (1).
7.
Remove capscrew (24), washer (23), snubber (19), mount (20), bushing (22), mount (20),
snubber (19), shim(s) (18) if present, and plate (17) from support ring (1) and "C" pillar support
bracket (21).
8.
Remove support ring (1) from vehicle.
Change 2
