TM 9-2320-280-34
14-4. SUPPORT RING MAINTENANCE (Cont'd)
d. Installation
1.
Install support ring (2) on vehicle.
2.
Install support ring (2) on "C" pillar support bracket (25) with plate (1), shim(s) (26) if removed,
snubber (22), mount (23), bushing (24), mount (23), snubber (22), washer (21), and capscrew (20).
Finger tighten capscrew (20).
3.
Install two front supports (3) on front mounting clevises (6) with two washers (4), capscrews (5),
washers (4), and locknuts (7).
4.
Install roof (para. 14-3).
Tighten two locknuts (7) to 26 lb-ft (35 Nm).
5.
6.
Install two connecting blocks (18) to "B" pillars (13) with four washers (12), capscrews (11),
washers (12), and locknuts (14). Tighten locknuts (14) to 21 lb-ft (29 Nm).
Tighten four screws (17) securing "B" pillar covers (19) to 15 lb-ft (20 Nm).
7.
8.
Install two striker plates (9) and two strap brackets (16) to "B" pillars (13) with four capscrews (10)
and locknuts (15). Tighten locknuts (15) to 21 lb-ft (29 Nm).
9.
Install four edge trim strips (8) on "B" pillar covers (19).
NOTE
Perform steps 10 and 11 for M966, M966A1, M1036, M1045,
M1045A1, M1045A2, M1046, and M1046A1 TOW vehicles only.
10.
Install TOW wiring harness clamp (29) to right "B" pillar cover (19) with screw (32) and assembled
locknut (30).
11.
Install cable stowage cleat (31) to support ring (2) with two washers (28) and capscrews (27).
Tighten capscrews (27) to 6 lb-ft (8 Nm).
14-10
Change 2
