TM 9-2320-280-34
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
_ ool
T___s
Man_____efere__ es
____ual R____ nc
General mechanic's tool kit:
TM 9-2320-280-24P
automotive (Appendix G, Item 1)
E___i____n___on__tion
_ qu pme_t C __di _
_ peci _ _ oo
S____al_T__ ls
Service brake rotors removed (TM 9-2320-280-20).
Axle shaft and seal installer
_____ enan __Lev
Maint_____ce ___ el
(Appendix G, Item 79)
Direct support
______al _ Part
Materi__s/____s
O-ring (Appendix E, Item 149)
Locknut (Appendix E, Item 53)
Sealing compound (Appendix B, Item 50)
a. Removal
NOTE
New configuration side mounting bracket allows for output shaft
seal replacement without bracket removal. Inspect bracket to
determine output shaft seal clearance. If clearance exists, perform
steps 2 through 4. If clearance does not exist, perform steps 1
through 4.
1.
Remove old configuration side mounting bracket (9) (para. 12-16).
2.
Remove locknut (5), O-ring (4), and output flange (3) from output shaft (2). Discard O-ring (4)
and locknut (5).
3.
Remove two capscrews (7) and brake adapter (6) from differential (1).
4.
Remove output shaft seal (8) from differential (1).
b. Installation
NOTE
New configuration side mounting bracket allows for output shaft
seal replacement without bracket removal. If side mounting
bracket was not removed, perform steps 2 through 4. If bracket
was removed, perform steps 1 through 4.
1.
Install new configuration side mounting bracket (9) (para. 12-16).
2.
Using axle shaft and seal installer, install output shaft seal (8) in differential (1).
CAUTION
Apply a liberal amount of thread sealing compound to the tapped
holes of differential. To allow adequate coating of threads, install cap-
screws shortly after applying thread sealing compound. Failure to do
this could allow capscrews to loosen and cause damage to differential.
3.
Apply sealing compound to tapped holes of differential (1) and install brake adapter (6) on differen-
tial (1) with two capscrews (7). Tighten capscrews (7) to 110-140 lb-ft (149-190 Nm).
4.
Install output flange (3), O-ring (4), and locknut (5) on output shaft (2). Tighten locknut (5) to
170 lb-ft (231 Nm).
Change 2
