TM 9-2320-280-34
REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Manual References
General mechanic's tool kit:
TM 9-2320-280-20
automotive (Appendix G, Item 1)
TM 9-2320-280-24P
Materials/Parts
Equipment Condition
Two O-rings (Appendix E, Item 149)
Service brake rotor removed
Four locknuts (Appendix E, Item 65)
(TM 9-2320-280-20).
Locknut (Appendix E, Item 53)
Maintenance Level
Sealing compound (Appendix B, Item 50)
Direct support
a. Removal
1.
Remove locknut (5), two O-rings (4), and output flange (3) from output shaft (2).
Discard O-rings (4) and locknut (5).
2.
Remove two capscrews (7) and brake adapter (6) from differential (1).
NOTE
New configuration side mounting bracket allows for output shaft
seal replacement without bracket removal. Inspect bracket to
determine output shaft seal clearance. If no clearance exists,
replacement of side mounting bracket with new configuration is
recommended.
3.
Remove two capscrews (12) and washers (13) from differential (1) and differential side mounting
bracket (14).
4.
Remove two locknuts (11), washers (8), capscrews (9), washers (8), differential support
bracket (10), and side mounting bracket (14) from suspension crossmember (15). discard
locknuts (11).
5.
Remove two locknuts (16), washers (17), capscrews (18), washers (17), and side mounting
bracket (14) from support bracket (10). Discard locknuts (16).
5
3
4
2
1
5
4
6
3
NEW CONFIGURATION
Change 2
