TM 9-2320-280-34
6-6. STARTER REPAIR (Cont'd)
16.
Remove two nuts (12), lockwashers (11), screws (8), copper washers (7) and two negative brush
leads (10) from starter motor frame (4). Disconnect two negative brush leads (10) and remove two
brushes (9). Discard two lockwashers (11).
17.
Remove two screws (1) and two positive brush leads (2) from field coil (3).
18.
Remove four springs (5) from brush holders (6).
19.
Remove four nut and lockwasher assemblies (14), rubber washers (15), and cover (16) from solenoid
housing (18). Pull cover (16) away from solenoid housing (18) far enough to allow access to series
winding connection (19) and screw (20). Discard rubber washers (15) and nut and lockwasher
assemblies (14).
20.
Remove screw (20) and washer (21) from series winding connection (19) on cover (16). Remove
cover (16) and gasket (17) from solenoid housing (18). Discard gasket (17).
21.
Hold core shaft (27) and remove nut (26), washer (25), and contact (24) from core shaft (27). Remove
core shaft (27), washer (22), and spring (23) from solenoid housing (18).
22.
Remove snapring (31), spring retainer (30), spring (29), spring retainer (28), rubber boot (32), and
washer (33) from core shaft (27). Discard snapring (31).
6-50
Change 2
