TM 9-2320-280-34
6-6. STARTER REPAIR (Cont' )
d
3.
Install gasket (1) on solenoid housing (2) and connect series winding connection (6) in cover (9) with
series winding connection (5) in solenoid housing (2) with washer (4) and screw (3).
4.
Install cover (9) on solenoid housing (2) with four rubber washers (7) and nut and lockwasher
assemblies (8).
5.
Install two negative brushes (18) and two positive brushes (22) on four brush holders (15) with springs
(14).
6.
Connect two positive brush leads (11) to field coil (12) with two screws (10).
7.
Connect two negative brush leads (19) to frame and field assembly (13) with two screws (17), copper
washers (16), lockwashers (20), and nuts (21). Cover heads of screws (17) with adhesive-sealant.
