TM 9-2320-280-34
6-6. STARTER REPAIR
This task covers:
a. Disassembly
d. Assembly
b. Cleaning
e. Bench Testing and Adjusting
c. Inspection
INITIAL SETUP:
Tools
Materials/Parts (Cont'd)
General mechanic's tool kit:
Pinion O-ring (Appendix E, Item 152)
automotive (Appendix G, Item 1)
Engine parts kit (Appendix E, Item 157)
Adhesive-sealant (Appendix B, Item 2)
Test Equipment
Aircraft grease (Appendix B, Item 20)
Switch (Appendix G, Item 91)
Lithium grease (Appendix B, Item 22)
Multimeter (Appendix G, Item 120)
Lubricating oil (Appendix B, Item 32)
Carbon pile (Appendix G, Item 92)
Core shaft nut tool (Appendix C, Fig. 3)
Armature test set (Appendix G, Item 93)
Manual References
Materials/Parts
TM 9-2320-280-20
Pinion stop and snapring kit
TM 9-2320-280-24P
(Appendix E, Item 47)
Equipment Condition
Thrust washer and spacer kit
Starter removed (TM 9-2320-280-20).
(Appendix E, Item 51)
Gasket set (Appendix E, Item 42)
Maintenance Level
Gasket set (Appendix E, Item 43)
Direct support
Solenoid parts kit (Appendix E, Item 161)
Gasket kit, commutator end head
(Appendix E, Item 41)
a. Disassembly
1.
Remove plug (4) and gasket (5) from pinion housing (3). Discard gasket (5).
2.
Using core shaft nut tool, remove nut (2) from end of core shaft (1) located inside pinion
housing (3).
Change 2
