TM 9-2320-280-34
6-6. STARTER REPAIR (Cont'd)
8.
Apply aircraft grease to armature shaft (32), shift lever studs (26), and the inside diameter of end
plate seal (34).
9.
Install washer (33), pinion housing end plate (36), gasket (37), and washer (30) on armature
shaft (32).
10.
Install clutch (29) on armature shaft (32) with pinion stop (28) and snapring (27).
NOTE
Armature and shift lever must be positioned as shown for
installation into pinion housing.
11.
Install shift lever (25) and armature (31) into pinion housing (38). Install pinion housing end
plate (36) on pinion housing (38) with three screws (35). Tighten screws (35) to 40 lb-in. (5 N.m).
12.
Install shift lever (25) on pinion housing (38) with pin (24) and two plugs (23).
12.
Install shift lever (25) on pinion housing (38) with pin (24) and two plugs (23).
