TM 9-2320-280-34
6-4. 200 AMPERE ALTERNATOR (A0013036AA) TESTING AND REPAIR (Cont'd)
14.
Install insulator (3) over three stator studs (2) with six spring washers (4), three washers (5) and
three nuts (6). Tighten nuts (6) to 16-18 lb-ft (22-24 N.m).
15.
Install two electrical brushes (15) over two brush springs (16).
16.
Install two brush leads (13) through brush cover (14) and diode trio panel (12) and install two
brushes (21) into brush holder (17).
17.
Connect two brush leads (13), lead 10 (24), lead 8 (27), and lead 11 (28) to diode trio panel (12) with
three lockwashers (25) and screws (26).
18.
Connect three negative rectifier leads (1) to three stator studs (2) with three nuts (7). Tighten
nuts (7) to 12-14 lb-ft (16-19 N.m).
19.
Install preformed packing (18), plate (19), and gasket (20) on brush holder (17).
20.
Position spacer (22) between diode trio panel (12) and brush cover (14) and retain in place by
installing insulation washer (8), washer (9), lockwasher (10), and screw (11) through diode trio
panel (12), spacer (22), brush cover (14) and brush holder (17). Repeat step for three remaining
spacers (22).
NOTE
Leads #1, #2, #3, #4 and #5 should be routed through opening
provided into the rectifier cavity of housing. Leads #8, #10 and
#11 will be attached to the regulator and should be routed toward
the outside of housing.
Change 2
