TM 9-2320-280-34
6-3.1. 100 AMPERE ALTERNATOR (12340912) REPAIR (Cont'd)
d. Assembly
1.
Install O-ring (14) in end housing (15).
2.
Install seal (16) flush in end housing (15) with lip facing away from end housing (15).
3.
Install end housing (15) on rotor shaft (17).
4.
Slide spacer (19) on rotor shaft (17) and into seal (16) with tapered end of spacer (19) facing away
from rotor (18).
5.
Apply a small amount of grease around spacer (19) and seal (16).
6.
Install preformed packing (20) on rotor shaft (17) and into taper of spacer (19).
7.
Press bearing (21) onto shaft (17) and into end housing (15).
8.
Place a small amount of grease in end housing (15) and on rotor shaft (17).
9.
Slide preformed packing (13) on rotor shaft (17).
10.
Slide spacer (22) on rotor shaft (17) with tapered end of spacer (22) toward preformed packing (13).
11.
Install flat washer (23) flush in end housing (15).
6-18.11
