TM 9-2320-280-34
6-3.1. 100 AMPERE ALTERNATOR (12340912) REPAIR (Cont'd)
NOTE
Prior to removal, tag rectifiers, rectifier leads and terminal pins
for installation.
Proceed to step 14 if rectifier leads are removed.
11.
Remove sealer from rear of electrical connector (4).
12.
Pull two rectifier terminal pins (3) and (5) out of electrical connector (4).
13.
Unsolder and pull three rectifier leads (2) or (6) out of two rectifier terminal pins (3) or (5).
14.
Remove sealer from rectifier(s) (1) or (7). Remove positive rectifier(s) (1) or negative rectifier(s) (7)
from rectifier mount(s) (8). Replace defective rectifier(s) (1) or (7).
15.
Inspect rectifier mounts (8) for breaks or cracks. Replace rectifier mount(s) (8) if defective.
16.
Inspect insulating sleeves (9) for breaks or cracks. Replace sleeves (9) if defective.
17.
Install rectifier(s) (1) or (7) in rectifier mount(s) (8).
NOTE
Proceed to step 23 if rectifier leads and terminal pins are installed.
Pin A is blank.
18.
19.
20.
Install rectifier terminal pins (3) and (5) in electrical connector (4).
21.
Apply adhesive sealant to rectifier(s) (1) or (7) and rectifier mounts (8).
22.
Apply adhesive sealant to rear of electrical connector (4).
23.
Inspect brushes (11) for roughness, galling, wear, and broken brush leads. Replace brushes (11) if
brush length is less than 0.187 in. (4.8 mm).
24.
Inspect brush holders (10) and six insulation washers (12) for cracks and breaks. Replace brush
holders (10) or insulation washers (12) if defective.
6-18.10
Change 1
