TM 9-2320-280-34
This task covers:
a. Removal
c. Installation
b. Inspection
INITIAL SETUP:
Tools
Equipment Condition
General mechanic's tool kit:
Fuel injection pump cover removed
automotive (Appendix G, Item 1)
Materials/Parts
Manual References
Three lockwashers (Appendix E, Item 101)
TM 9-2320-280-20
Locknut (Appendix E, Item 52)
TM 9-2815-237-34P
Two shouldered washers
Maintenance Level
(Appendix E, Item 263)
Direct support
NOTE
Working area should be clean, well ventilated, and free from
blowing dirt and dust.
a. Removal
1.
Remove terminal (5), washer (6), and shell (7) from stud (12).
2.
Remove nut (8), lockwasher (9), washer (10), and shouldered washer (11) from stud (12). Discard
lockwasher (9) and shouldered washer (11).
3.
Remove locknut (4), ground strap (3), lockwasher (2), nut (8), lockwasher (9), washer (10), and
shouldered washer (11) from stud (14). Discard locknut (4), lockwashers (2) and (9), and shouldered
washer (11).
4.
Remove electrical shutoff solenoid (13) from cover (1).
b. Inspection
Inspect shell (7) for deterioration, cracks, or damage. Replace if cracked, deteriorated, or damaged.
c. Installation
1.
Install electrical shutoff solenoid (13) in cover (1).
2.
Install shouldered washer (11), washer (10), lockwasher (9), nut (8), lockwasher (2), ground
strap (3), and locknut (4) on stud (14).
3.
Install shouldered washer (11), washer (10), lockwasher (9), and nut (8) on stud (12).
4.
Install shell (7), washer (6), and terminal (5) on stud (12).
Change 2
