TM 9-2320-280-34
4-7. FUEL INJECTION PUMP COVER REPLACEMENT (Cont'd)
2.
Install washer (11) between ground strap (12) and cover (4).
3.
Install gasket (13) on fuel injection pump housing (14).
_AUTION
C _____
Incorrect installation of cover may cause damage to cover
gasket or pump to malfunction.
4.
Install retaining tool on cover (4) to restrict shutoff solenoid linkage (15).
5.
Position cover (4) over fuel injection pump housing (14) ahead of threaded holes in housing and
slide rearward and downward to align holes in cover (4) with threaded holes in housing (14).
6.
Twist retaining tool to release solenoid linkage (15) and slide tool out from between cover (4) and
fuel injection pump housing (14). Take care not to damage gasket (13).
7.
Secure cover (4) with three screws (9), lockwashers (10), and washers (11). Tighten screws (9) to
34-45 lb-in. (4-5 Nm).
8.
Connect fuel drain back hose (1) to fuel injection pump (6) with clamp (2).
9.
Connect battery ground cable (TM 9-2320-280-20).
_AUTION
C _____
Do not attempt to start engine until all the following steps are
completed. If no clicking noise is present in the cover of the fuel
injection pump, the linkage may possibly be jammed in the wide
open throttle position. If engine is started with linkage in wide open
throttle position, engine runaway will occur and engine damage will
result.
10.
Place rotary switch to "RUN" position. Listen for a clicking noise when connecting and
disconnecting lead 54A (3) to fuel injection pump (6). If no clicking noise is present, remove and
reinstall cover (4). If clicking noise is present, connect harness leads 54A (3) and 569B (5) to fuel
injection pump (6).
9
8
10
3
7
1
11
2
12
4
11
5
4
13
14
RETAINING
TOOL
4
6
15
FOLLOW-ON TASKS: Start engine (TM 9-2320-280-10) and check for fuel leaks.
Lower and secure hood (TM 9-2320-280-10).
4-15
