TM 9-2320-280-34
This task covers:
a.
Removal
c. Installation
b.
Inspection
INITIAL SETUP:
Tools
Equipment Condition
General mechanic's tool kit:
Hood raised and secured (TM 9-2320-280-10).
automotive (Appendix G, Item 1)
Maintenance Level
Manual References
Direct support
TM 9-2320-280-10
TM 9-2320-280-20
TM 9-2815-237-34P
a. Removal
1.
Loosen two nuts (7) and disconnect cable assembly (1) from accelerator bracket (5).
2.
Disconnect throttle return spring (2) from bracket (5).
3.
Remove stop collar (6) and disconnect cable assembly (1) from fuel injection pump (4).
4.
Remove nut (8) and washer (9) from fuel injection pump (4) and stud (11).
5.
Remove two capscrews (10) and bracket (5) from fuel injection pump (4).
b. Inspection
Inspect throttle return spring (2) for damage. Replace if defective.
c. Installation
1.
Install bracket (5) on fuel injection pump (4) and stud (11) with washer (9) and nut (8).
2.
Install bracket (5) on fuel injection pump (4) with two capscrews (10). Tighten capscrews (10) to
13 lb-ft (18 N m).
3.
Position throttle shaft lever (3) to full throttle position and secure cable assembly (1) to throttle
shaft lever (3) with stop collar (6).
4.
Connect throttle return spring (2) to bracket (5).
5.
Install cable assembly (1) to bracket (5) with two nuts (7).
